It is made of high-quality cold-rolled plate through stamping, seam welding, spraying and other procedures, and the quality is reliable. It is widely used to hold petroleum, chemical, pesticide, and food products. And the barrel-making process of open barrels: Barrel body cutting, barrel lid stamping, composite ring stamping, logo stamping, rounding, spot welding, seam welding, ring ribs, flange, necking, pipe rolling, curling, point ladder , Hoop body cutting, roll forming, hoop ear spot welding, hoop ear gas welding, blanking, punching, tight ear drum, stamping forming, handle electric welding, accessory assembly, seal spot welding, surface treatment, paint spraying , Silk-screen printing of spray marks, plastic injection of barrel lids, final assembly inspection.
In the workshop, safety also attaches great importance to safety issues. The production specifications are summarized as follows.
1. Be familiar with the performance of mechanical equipment and supporting tools and master the necessary safety skills;
2. It is strictly forbidden to run in the workshop to prevent slipping and hurt people;
3. When operating rotating machinery and equipment, work clothes must be tight and it is strictly forbidden to wear a tie or a towel;
4. Do not use the equipment if you don’t understand the performance of the mechanical equipment or have not been trained and qualified;
5. Be concentrated during work and not do anything unrelated to work;
6. No slippers or bare feet are allowed in the workshop;
7. Do not move or dismantle protective devices and safety facilities;
8. To maintain adequate rest time, do not drink alcohol 4 hours before going to work;
9. You must wear protective equipment when engaging in toxic and harmful work or in toxic and harmful places;
10. The placement of items in the workshop of Volkswagen Container Factory must strictly implement the "5S" requirements;
11. Multiple assignments are not allowed at the same working point;
12. Close doors, windows, water, electricity, gas, and cover dangerous chemicals and labor protection equipment when you leave work.
Masks. Gauze masks are mainly used to prevent toxic and harmful dust in the air from being inhaled into the human body. Dust masks should be replaced in time if they are dirty and smelly if they are used within the specified period. Shanxi open barrel manufacturers remind you that masks are mainly used to prevent toxic and harmful gases in the air from inhaling the human body. After use, the mask should be placed in a designated place and cannot be placed anywhere. The mask should be checked before use. If it is found to be broken and leaking, it should be replaced in time Do not use. Masks should be replaced with carbon particles and filter pads after use for about three to four months. Protective glasses are mainly used for splashing and hurting eyes during the operation of iron drum production machinery. Check the visibility of protective glasses before use, if they are blurred Replace in time when it affects work. The Shanxi open barrel manufacturer reminds you that the protective glasses should be placed in a designated place after use to prevent the lens from scratching. Protective gloves are mainly used to avoid sharp burrs, water chestnuts, and cutting edges during operations such as handling and machining iron buckets. After use, they should be properly stored. If they are soaked in water, they should be dried in time or replaced with electrical safety.
When the equipment fails, the power must be cut off immediately, and the maintenance personnel shall be notified in time not to work or repair without authorization. Observe the safety power regulations. It is strictly forbidden to pull wires and dismantle or modify electrical lines. Do not open or close the switch at will , When using the ground wire, check the integrity of the circuit. If it is damaged, replace it immediately. Disconnect the equipment from the power supply line and place the mobile equipment in the designated place after use. The electrical equipment must be regularly maintained. The power must be disconnected during maintenance, and the bare wire must not be directly inserted into the socket.